The W-style design will raise the properties of the tube, so if bending, expanding, drilling, or other operations are to be done to the tube, another design style should be consideredĮven with the limitations of the W-style, it remains a widely used and acceptable method for designing tooling.We recommend replacing the #1 top rolls for various gauges. Although it is not recommended, this style can be used when running multiple tube and pipe sizes, as long as the smallest size is not less than 80% of the largest size.This flat spot can remain in the strip through the sizing rolls, so it is very important to work the second pass to take out the center “hump” from the “W” pass. The tube can have a flat spot if the second pass is not built for the correct gauge and used properly. Oneflex Elastomeric Pipe Roll Insulators are used for insulation of all equipment pipes of cooling and heating equipment at. ![]() Drive and ratio are often issues, due to multiple diameters and surface speeds in the first pass.It pre-forms more of the strip, giving greater stability, and provides a better presentation into the fin passes.īy comparison, there are some reasons that another design method may be a better choice: W-style can form more of the strip in the first pass than Edgeform or Versatile designs. It can be combined with a versatile design for maximum results on light-gauge, high-strength material. The W-style (reverse bending) method of designing breakdown rolls is recommended when forming high-strength very light or very heavy gauge materials. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |